THE EASY-TO-APPLY HOT MELT EDGING FOR CHIPBOARD, MDF AND OTHER LAMINATED BOARDS
White stipple Pre-glued 21mm x 50 metres
Application Instructions
This edge strip is already pre-coated with a hot melt adhesive and is applied by heat reactivation by means of an electronic iron, or is usable on a wide variety of hot air, hot roller or hot platen type edge banding machines.
Method;
Place the edge strip into position, making sure that the cut edge of the board is free from dust and grease. Cover the face of the edge strip with a piece of brown paper or backing paper, then place a hot domestic iron (wool setting) on top, moving it behind the iron with a rolled cloth pad, applying enough pressure to keep the laminate strip in tight contact with the edge for several seconds whilst bond is made. When completely cool, clean off overlap with a plane or file at an angle of 15 degrees to the surface. Work towards the surface of the board so as not to pull the strip away. Finish off with careful use of the sand paper wrapped around a rubbing block.T
Reviews
There are no reviews yet.